Component Testing
WARNING: This page is about a different car, the 2008 GMC Sierra and 2008 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Perform the Shift Solenoid Leak Test
.
- If the solenoid fails the shift solenoid leak test, replace the affected solenoid.
- Disconnect the wiring harness connector from the affected solenoid. Measure the resistance for the affected solenoid. The resistance should be between 15-20.3 ohms for the 1-2 SS, 2-3 SS and the 4-5 SS. The resistance should be between 10-13.6 ohms for the TCC PWM solenoid.
- If the resistance is not within the specified range, replace the affected solenoid.