LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1044 (Engine Controls And Fuel - 4.8L, 5.3L, 6.0L, 6.2L, Or 7.0L - DTC P0010 To DTC P0230) >> DTC P0016 (w/LY6) >> Circuit/System Verification (w/LY6)

Circuit/System Verification (w/LY6)

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Start the engine.
  2. Allow the engine to reach normal operating temperature.
  3. Allow the engine to idle.
  4. With a scan tool, monitor the Desired CMP, CMP Angle, and the CMP Variance parameters. All 3 parameters should display less than 1 degree.
  5. Using the scan tool output control function, command the CMP actuator to 25 degrees. The Desired CMP and the CMP Angle parameter should display 25 degrees. The CMP Variance Angle will rise for 2-3 seconds until the Desired and Actual parameters values match, then the CMP Variance parameter should return to zero degrees.
    • If the vehicle passes the Circuit/System Verification Test, then operate the vehicle within the Conditions For Running The DTC. You may also operate the vehicle within the conditions that are captured in the Freeze Frame/Failure Records Data list.
scientia non olet · About LEMON Manuals