Conditions for Running the DTC

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

DTC P0010, P0016, P0335, P0336, P0340, or P0341 is not set.
The engine is running.
The system voltage is between 9 and 18 volts.
The CMP actuator is enabled.
The power take off (PTO) is not active.
The rate of change in the camshaft position is less than, 7.5 degrees for 3.35 seconds.