LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1044 (Engine Controls And Fuel - 4.8L, 5.3L, 6.0L, 6.2L, Or 7.0L - DTC P0010 To DTC P0230) >> DTC P0010 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON, engine running, increase engine speed to between 1,200-1,500 RPMs. Monitor the camshaft actuator solenoid with a scan tool, while observing the following control circuit status parameters:
    • The CMP actuator solenoid ckt short to gnd test status
    • The CMP acutator solenoid ckt open test status
    • The CMP actuator solenoid ckt short to volts test status

      Each parameter should display OK.

  2. Operate the vehicle within the conditions for running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the freeze frame/Failure Records data.
scientia non olet · About LEMON Manuals