LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1037 (Tire Pressure Monitoring System) >> Repair Instructions >> Tire Pressure Indicator Sensor Replacement (Snap In Style) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle on a suitable support. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire/wheel assembly from the vehicle. Refer to Tire and Wheel Removal and Installation .
  3. Dismount the tire from the rim. Refer to Tire Mounting and Dismounting .
    4. IMPORTANT: When servicing the tire pressure sensor always use a new Schrader® tire pressure monitor (TPM) and a new TORX screw during installation.
    Fig 1: View Of Tire Pressure Indicator Sensor
    GM1748887Courtesy of GENERAL MOTORS CORP.
  4. Remove the TORX screw (1) from the tire pressure sensor (2) and pull it straight off the tire pressure valve stem (3).
    5. NOTE: Do not scratch or damage the clear coating on aluminum wheels with the tire changing equipment. Scratching the clear coating could cause the aluminum wheel to corrode and the clear coating to peel from the wheel.
  5. Remove the tire pressure valve stem by pulling it through the rim.
scientia non olet · About LEMON Manuals