Two-Wheel-Drive Output Shaft Bushing Inspection
WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Inspect the output shaft bushing (2) for wear or damage.
- Measure the inside diameter (ID) of the bushing (2) at dimension A. Replace the bushing If the ID of the bushing exceeds specification.
Specification: The bushing maximum ID is 20.070 mm (0.7940 in).
- Measure the outside diameter (OD) of the bearing surface at dimension B. Replace the output shaft If the OD of the bearing surface exceeds specification
Specification: The bearing minimum OD is 44.978 mm (1.7708 in)