Turbine Speed Sensor Installation: Installation

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: VSS And Bolt

Courtesy of GENERAL MOTORS CORP.

Install the vehicle speed sensor O-ring (3) onto the turbine speed sensor (2).
Apply J 36850 to the O-ring (3). See Special Tools .
Install the turbine speed sensor (2) into the transmission case.
Install the vehicle speed sensor bolt (1) into the transmission case.
NOTE: Refer to Fastener Notice .

Tighten: Tighten the bolt to 12 N.m (108 lb in).