LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1035 (Automatic Transmission - ALLISON - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Off-Vehicle Repair Information >> Torque Converter Housing with Fluid Pump Assembly Removal

Torque Converter Housing with Fluid Pump Assembly Removal

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating Transmission Case Bolts
    GM1207590Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Torque Converter Housing/Low and Reverse Clutch Housing Bolt Size Notice .
  1. Remove 18 bolts (1), one bolt (2), and one bolt (3).
    2. Fig 2: View Of Torque Converter Housing with Fluid Pump Assembly
    GM1914739Courtesy of GENERAL MOTORS CORP.
    CAUTION: The torque converter housing/oil pump cover assembly dry weights are approximately 27 kg (60 lb). To help avoid personal injury and/or property damage:
    • Use caution when installing, removing, or moving the converter housing/oil pump cover assembly.
    • Get help when lifting the converter housing/oil pump cover assembly.
    • Assistance from a hoist or another person may be required.
    • Make sure lifting equipment can properly support the converter housing/oil pump cover assembly.
  2. Attach a sling to the converter housing (1).
  3. Attach a hoist to the sling.
  4. Remove the converter housing/oil pump cover assembly (1) from the transmission case (4) and the turbine shaft (2).
  5. Place the converter housing/oil pump cover assembly on the work table.
  6. Remove the sling.
  7. Remove and discard the main housing/separator plate gasket (3).
scientia non olet · About LEMON Manuals