Removal Procedure
WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Use caution when installing, removing, or moving the torque converter.
- Get help when lifting the torque converter. Assistance from a hoist or another person is required.
- Make sure J 46409 T-handles are installed securely and that any lifting equipment used can properly support the torque converter.
- Position the transmission so that the front of the torque converter is facing up.
- If used, remove 4 bolts and 2 shipping brackets, or remove any other torque converter restraining device.
- Install 1 J 46409 T-handle into a boss on the front of the torque converter. See Special Tools .
- Install the other J 46409 T-handle into a boss on the front of the torque converter 180 degrees away from the first T-handle. See Special Tools .
- Remove the torque converter from the converter housing.
- Place the torque converter on the work table.
CAUTION:
The torque converter dry weight is approximately 29 kg (63 lb). To help avoid personal injury and/or property damage:
CAUTION:
Avoid personal injury or property damage when removing or installing the torque converter by seeking an assistant to help lift the torque converter.