LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1035 (Automatic Transmission - ALLISON - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Off-Vehicle Repair Information >> Stator Shaft Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Stator Shaft
    GM1217384Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Remove the needle bearing only if replacing both the bearing and the stator shaft.
  1. Position the oil pump cover assembly (2) on a press bed so that the assembly is supported by wooden blocks and the stator shaft is facing down.
  2. Install the short end of J 43765-2 remover (1) into the rear of the oil pump cover assembly.
  3. Press the stator shaft from the oil pump cover assembly (2).
scientia non olet · About LEMON Manuals