Section 1032 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Introduction (2 Of 2))
WARNING: This page is about a different car, the 2008 GMC Sierra and 2008 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Transmission Fluid Temperature Sensor Specifications
- Fastener Tightening Specifications
- Transmission General Specifications
- Fluid Capacity Specifications
- End Play Specifications
- Low and Reverse Clutch Spacer Plate Selection
- Forward Clutch Backing Plate Selection
- Third and Fourth Clutch Backing Plate Selection
- Reverse Input Clutch Backing Plate Selection
- Oil Pump Rotor and Slide Measurement
- Torque Converter End Play Specifications
- Torque Converter End Play Inspection
- 2-4 Band Servo Piston Pin Selection
- Range Reference
- Shift Solenoid Valve State and Gear Ratio
- Shift Speed
- Transmission Fluid Pressure Manual Valve Position Switch Logic
- Transmission Range Switch Logic
- Line Pressure
- Component Resistance
- Schematic and Routing Diagrams
- Component Locator
- Diagnostic Information and Procedures