Scan Tool Output Controls
WARNING: This page is about a different car, the 2008 GMC Sierra and 2008 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
| Scan Tool Output Control | Additional Menu Selections | Description |
|---|---|---|
| Refer to the scan tool manual for complete scan tool operating instructions.
IMPORTANT:
Transmission must be in transmission neutral for any of these output controls to operate.
|
||
| 2WD High Indicator Light | - | This function allows the technician to command the 2WD high indicator light, within the transfer case shift control switch, on or off. |
| 4WD High Indicator Light | - | This function allows the technician to command the 4WD high indicator light, within the transfer case shift control switch, on or off. |
| 4WD Low Indicator Light | - | This function allows the technician to command the 4WD low indicator light, within the transfer case shift control switch, on or off. |
| ATC Motor Learn | - | This function allows the technician to command the transfer case shift control module to relearn the clutch status after the encoder motor, module, or transfer case is replaced. |
| Auto 4WD Indicator Light | - | This function allows the technician to command the auto 4WD indicator light, within the transfer case shift control switch, on or off. |
| Neutral Indicator Light | - | This function allows the technician to command the neutral indicator light, within the transfer case shift control switch, on or off. |