Rear Output Shaft Bushing Replacement

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Output Shaft Bushing Replacement

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure: Ensure the bushing is installed squarely into the bushing bore.
1	Transfer Case Rear Output Shaft Bushing Tip: Press the bushing until the tool bottoms on the rear case half. Special Tools J 8092 Driver Handle DT-48022 Output Bushing Installer DT-48209 Bushing Remover

Callout

Component Name

Preliminary Procedure:
Ensure the bushing is installed squarely into the bushing bore.

Transfer Case Rear Output Shaft Bushing
Tip: Press the bushing until the tool bottoms on the rear case half.

Special Tools

J 8092 Driver Handle
DT-48022 Output Bushing Installer
DT-48209 Bushing Remover