Stationary PTO: Notes
WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
The stationary PTO mode will disengage if any of the following conditions are detected by the vehicle modules:
- Vehicle movement
- The park brake is released
- The transmission is shifted from PARK (P) or NEUTRAL (N) to DRIVE (D) or REVERSE (R).
- The PTO load becomes disengaged
- Press and release the 0 button on the PTO in-cab switch
- Move the speed enable switch to the OFF position on the remote PTO controls
- Press the remote engine shutdown switch (stationary remote PTO only)