Connect Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Lubricating Male Pipe End

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to Fuel Pipe Fitting Caution .

Apply a few drops of clean engine oil to the male connection end.

Fig 2: Connecting Quick-Connect Fittings

Courtesy of GENERAL MOTORS CORP.

Push both sides of the quick-connect fitting together in order to cause the retaining feature to snap into place.

Fig 3: Ensuring Secure Connection

Courtesy of GENERAL MOTORS CORP.

Once installed, pull on both sides of the connection in order to make sure the connection is secure.
Install the fuel fill cap.
Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (w/Single Battery) or Battery Negative Cable Disconnection and Connection (w/Auxiliary Battery) or Battery Negative Cable Disconnection and Connection (w/Dual Batteries) .