LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1026 (Engine Controls And Fuel - 6.6L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Tank Replacement (Cab/Chassis - Front) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Fuel Tank, Strap & Bolts (Cab/Chassis - Front)
    GM1228169Courtesy of GENERAL MOTORS CORP.
  1. If the fuel tank was replaced, install the sending unit. Refer to Fuel Sender Assembly Replacement .
  2. Remove the caps from the fuel lines.
  3. With the aid of an assistant, place the fuel tank on the jack.
  4. Raise the fuel tank.
  5. Install the fuel tank straps.
    NOTE: Refer to Fastener Notice .
  6. Install the fuel tank strap bolts.

    Tighten:  Tighten the bolts to 40 N.m (30 lb ft).

  7. Remove the jack from under the fuel tank.
    8. Fig 2: Fuel Tank Shield & Bolts (Cab/Chassis - Front)
    GM877744Courtesy of GENERAL MOTORS CORP.
  8. If necessary, install the fuel tank shield.
  9. If necessary, install the fuel tank shield bolts.

    Tighten:  Tighten the bolts to 18 N.m (13 lb ft).

  10. Lower the vehicle.
    11. Fig 3: Fuel Feed & EVAP Quick Connect Fittings At Sending Unit
    GM1228206Courtesy of GENERAL MOTORS CORP.
  11. Connect the fuel feed and return lines at the fuel tank. Refer to Metal Collar Quick Connect Fitting Service .
    12. Fig 4: Fuel Pressure Sensor Electrical Connector & Fuel Sending Unit Electrical Connector
    GM1238183Courtesy of GENERAL MOTORS CORP.
  12. Connect the sending unit electrical connectors (1).
    13. Fig 5: View Of Fuel Fill Pipe Clamp & Vent Pipe Clamp
    GM1228174Courtesy of GENERAL MOTORS CORP.
  13. Install the fuel fill pipe and vent hose to the tank.
  14. Tighten the fuel fill and vent hose clamps (1, 2) at the fuel tank.

    Tighten:  Tighten the clamps to 2.5 N.m (22 lb in).

    15. Fig 6: View Of Fuel Feed And Pressure Balance Lines
    GM1228187Courtesy of GENERAL MOTORS CORP.
  15. Connect the fuel feed and pressure balance rear lines. Refer to Metal Collar Quick Connect Fitting Service .
  16. Fill the fuel tank.
  17. Install the fuel fill cap.
  18. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (w/Single Battery) or Battery Negative Cable Disconnection and Connection (w/Auxiliary Battery) or Battery Negative Cable Disconnection and Connection (w/Dual Batteries) .
  19. Prime the fuel system. Refer to Fuel System Priming .
  20. Start the engine. If the engine stalls, repeat the above step.
  21. Once the engine starts, inspect for fuel leaks.
scientia non olet · About LEMON Manuals