LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1026 (Engine Controls And Fuel - 6.6L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Hose/Pipes Replacement - Chassis (Cab/Chassis w/Balance Pump) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Sending Unit Electrical Connector (Cab/Chassis - Rear)
    GM1333147Courtesy of GENERAL MOTORS CORP.
  1. Remove the front and auxiliary fuel tanks. Refer to Fuel Tank Replacement (Pickup)  or Fuel Tank Replacement (Cab/Chassis - Front)  or Fuel Tank Replacement (Cab/Chassis - Rear) .
  2. Disconnect the pressure balance pump electrical connector.
    3. Fig 2: View Of Fuel Bundle (Cab/Chassis w/Balance Pump)
    GM1228195Courtesy of GENERAL MOTORS CORP.
  3. Remove the fuel bundle nuts.
  4. Remove the fuel bundle.
scientia non olet · About LEMON Manuals