LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1026 (Engine Controls And Fuel - 6.6L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Hose/Pipes Replacement - Chassis (Cab/Chassis w/Balance Pump) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Fuel Bundle (Cab/Chassis w/Balance Pump)
    GM1228195Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the fuel bundle.
  2. Install the fuel bundle nuts.

    Tighten:  Tighten the nuts to 16 N.m (12 lb ft).

    3. Fig 2: View Of Sending Unit Electrical Connector (Cab/Chassis - Rear)
    GM1333147Courtesy of GENERAL MOTORS CORP.
  3. Connect the pressure balance pump electrical connector.
  4. Install the front and auxiliary fuel tanks. Refer to Fuel Tank Replacement (Pickup)  or Fuel Tank Replacement (Cab/Chassis - Front)  or Fuel Tank Replacement (Cab/Chassis - Rear) .
scientia non olet · About LEMON Manuals