LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1026 (Engine Controls And Fuel - 6.6L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Hose Replacement - Fuel Injection Pump to Fuel Feed Block >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Fuel Filter Hoses & Clamps
    GM1872011Courtesy of GENERAL MOTORS CORP.
  1. Install the fuel hose (4) to the fuel injection fuel feed manifold and injection pump.
  2. Position the fuel hose clamp (3) at the fuel injection pump.
    3. Fig 2: View Of Fuel Hose Clamps
    GM1872010Courtesy of GENERAL MOTORS CORP.
  3. Position the fuel hose clamp (2) at the fuel injection fuel feed manifold.
  4. Install the intake manifold tube. Refer to Intake Manifold Tube Replacement .
  5. Install the water outlet. Refer to Water Outlet Tube Replacement (LMM) .
  6. Prime the fuel system. Refer to Fuel System Priming .
  7. Start the engine. If the engine stalls, repeat the above step.
  8. Once the engine starts, inspect for fuel leaks.
scientia non olet · About LEMON Manuals