LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1026 (Engine Controls And Fuel - 6.6L - Introduction (2 Of 2)) >> Repair Instructions >> Exhaust Gas Recirculation Valve Temperature Sensor Replacement - Position 1

Exhaust Gas Recirculation Valve Temperature Sensor Replacement - Position 1

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Exhaust Gas Recirculation Valve Temperature Sensor Replacement - Position 1
GM1998257Courtesy of GENERAL MOTORS CORP.
Callout Component Name
  1. Remove the engine cover.
  2. Remove the air cleaner. Refer to Air Cleaner Assembly Replacement .
1 EGR Temperature Sensor Assembly
NOTE: Refer to Fastener Notice .

Tighten:  44 N.m (32 lb ft)

Procedure

  1. Disconnect the harness connector.
  2. Detach the EGR temperature sensor assembly harness connector from the bracket.
scientia non olet · About LEMON Manuals