LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1026 (Engine Controls And Fuel - 6.6L - Introduction (2 Of 2)) >> Repair Instructions >> Exhaust Gas Recirculation Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of EGR Valve, Bolts & Gaskets
    GM1873229Courtesy of GENERAL MOTORS CORP.
  1. Remove the exhaust gas recirculation (EGR) valve cooler. Refer to Exhaust Gas Recirculation Valve Cooler Replacement .
  2. Remove the EGR valve gaskets (1), if required.
  3. Remove the EGR valve bolts (2).
  4. Remove the EGR valve (3).
  5. Remove and discard the EGR valve to valve cooler gasket.
scientia non olet · About LEMON Manuals