LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1026 (Engine Controls And Fuel - 6.6L - Introduction (2 Of 2)) >> Repair Instructions >> Exhaust Gas Recirculation Valve Motor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of EGR Valve Motor
    GM1873223Courtesy of GENERAL MOTORS CORP.
  1. Position the EGR spacer (if equipped), and NEW EGR valve motor to the EGR valve.
    2. NOTE: Refer to Fastener Notice .
  2. Install the EGR valve motor screws.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

    3. Fig 2: View Of Intake Air Valve Electrical Connector
    GM1871112Courtesy of GENERAL MOTORS CORP.
  3. Connect the engine wiring harness electrical connector (1) to the EGR valve motor.
  4. Install the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
  5. Cycle the ignition to relearn the new EGR valve motor pintle position.
scientia non olet · About LEMON Manuals