LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1026 (Engine Controls And Fuel - 6.6L - Introduction (2 Of 2)) >> Repair Instructions >> Camshaft Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Camshaft Position Sensor
    GM1334865Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the CMP sensor O-ring with clean engine oil.
  2. Install the CMP sensor.
    NOTE: Refer to Fastener Notice .
  3. Install the CMP sensor bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

  4. Install the cooling fan pulley. Refer to Cooling Fan Pulley Replacement .
scientia non olet · About LEMON Manuals