LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1026 (Engine Controls And Fuel - 6.6L - Introduction (2 Of 2)) >> Repair Instructions >> Air Cleaner Element Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Air Filter Element
    GM1606539Courtesy of GENERAL MOTORS CORP.
  1. Stand facing the front fender on the passenger side of the vehicle. Insert the element into the housing. Place the palm of your hand on the inboard end of the element, and press the element into position.
  2. Press both downward and inboard until the outboard end of the element clicks into place inboard of the locating tab.
    3. NOTE: Refer to Fastener Notice .
  3. Install the air cleaner housing door and tighten the screw.

    Tighten:  Tighten the screw to 4 N.m (35 lb in).

scientia non olet · About LEMON Manuals