Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra and 2008 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Fuel Level Sensor

Courtesy of GENERAL MOTORS CORP.

Position the fuel level sensor over the slot in the reservoir and slide the sensor down into the slot.

Fig 2: Fuel Level Sensor Wiring Pigtail, Module Clip & Retainers

Courtesy of GENERAL MOTORS CORP.

Ensure that the fuel level sensor retainers (1) engage the module reservoir.
Install the fuel level sensor wiring pigtail under the module clip (2).

Fig 3: Fuel Level Sensor Wiring Pigtail Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Connect the fuel level sensor wiring pigtail electrical connector (1) to the module cover.
Install the fuel tank module. Refer to Fuel Sender Assembly Replacement (Regular Cab w/34 Gal Tank) or Fuel Sender Assembly Replacement (Regular Cab w/26 Gal Tank) or Fuel Sender Assembly Replacement (Extended Cab w/26 Gal Tank) .