Removal Procedure
WARNING: This page is about a different car, the 2008 GMC Sierra and 2008 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the fuel tank filler housing to body TORX® screws (1) and pushpin retainer (2).
- Remove the fuel tank filler housing to fuel tank fill pipe bolts.
- Remove the fuel tank filler housing.
- Raise and suitably support the vehicle half way. Refer to Lifting and Jacking the Vehicle .
- Remove the fuel tank fill pipe ground wire bolt.
- Remove the fuel tank fill pipe ground wire anti-rotation tab from the frame hole.
- Reposition the fuel tank fill pipe ground wire.
- Open the axle vent hose clip on the fuel fill pipe bracket.
- Remove the rear axle vent hose from the clip.
- Disconnect the fuel tank evaporative emission (EVAP) line quick connect fitting (2) from the fuel fill pipe recirculation line. Refer to Plastic Collar Quick Connect Fitting Service .
- Loosen the fuel tank fill pipe clamp (1) at the fuel tank.
- Remove the fuel tank fill pipe.
- Cap the opening on the fuel tank in order to prevent possible system contamination.