LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1025 (Engine Controls And Fuel - 4.3L - Introduction (2 Of 2)) >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra and 2008 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Pan Skid Plate & Bolts
    GM1698082Courtesy of GENERAL MOTORS CORP.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. If equipped, remove the oil pan skid plate and bolts.
    3. Fig 2: View Of Engine Wiring Harness & Components
    GM1876999Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the engine wiring harness electrical connector (4) from the crankshaft position (CKP) sensor.
    4. Fig 3: View Of CKP Sensor & Bolt
    GM1877000Courtesy of GENERAL MOTORS CORP.
  4. Remove the CKP sensor bolt and sensor.
scientia non olet · About LEMON Manuals