LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1025 (Engine Controls And Fuel - 4.3L - Introduction (2 Of 2)) >> Repair Instructions >> Air Cleaner Element Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra and 2008 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Air Cleaner Housing, Filter & Screws
    GM1877033Courtesy of GENERAL MOTORS CORP.
  1. Insert the NEW air filter element.
  2. Install the air cleaner housing cover.
    NOTE: Refer to Fastener Notice .
  3. Tighten the air cleaner housing screws.

    Tighten:  Tighten the screws to 3 N.m (27 lb in).

    4. Fig 2: View Of Engine Wiring Harness Electrical Connector
    GM1876316Courtesy of GENERAL MOTORS CORP.
  4. Connect the engine wiring harness electrical connector (1) to the MAF/IAT sensor.
    5. Fig 3: View Of Air Cleaner Outlet Resonator & Clamps
    GM1877032Courtesy of GENERAL MOTORS CORP.
  5. Install the air cleaner outlet resonator to the MAT/IAT sensor.
  6. Tighten the air cleaner outlet resonator clamp (1) at the MAF/IAT sensor.

    Tighten:  Tighten the clamp to 4 N.m (35 lb in).

scientia non olet · About LEMON Manuals