LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1024 (Power Seat System) >> Diagnostic Information and Procedures >> Power Seat Inoperative (w/o Memory) >> Component Testing

Component Testing

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Seat Adjuster Switch Test

  1. Ignition OFF, disconnect the harness connector at the seat adjuster switch.
  2. Test for infinite resistance between each control terminal and the B+ terminal with the switch in the open position.
    • If less than the specified value, replace the seat adjuster switch.
  3. Test for less than 1 ohm between each control terminal and the B+ terminal with the switch in the closed position.
    • If greater than the specified range, replace the seat adjuster switch.
  4. Test for less than 1 ohm between each control terminal and the ground terminal with the switch in the open position.
    • If greater than the specified range, replace the seat adjuster switch.