LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1018 (Power Steering System) >> Repair Instructions >> Power Steering Gear Inlet Pipe/Hose Replacement (Diesel) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place drain pans under the vehicle as needed.
    2. Fig 1: View Of Power Steering Gear Inlet Hose & Clip Bolt
    GM1891219Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the power steering gear inlet hose (1) from the power brake booster.
  3. Remove the power steering gear inlet hose clip bolt (3).
  4. Disconnect the power steering gear inlet hose (4) from the steering gear.
  5. Remove the power steering gear inlet hose (2) from the vehicle.
scientia non olet · About LEMON Manuals