LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1018 (Power Steering System) >> Repair Instructions >> Power Steering Fluid Cooler Replacement (With Hydroboost) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Power Steering Cooler & Bolts
    GM686121Courtesy of GENERAL MOTORS CORP.
  1. Install the power steering fluid cooler (1) to the vehicle.
    2. NOTE: Refer to Fastener Notice .
  2. Install the power steering fluid cooler bolts (2).

    Tighten:  Tighten the bolts to 9 N.m (80 lb in)

    3. Fig 2: View Of Power Steering Pump & Components
    GM1863708Courtesy of GENERAL MOTORS CORP.
  3. Connect the power steering fluid cooler hose (4) to the power steering pump (1).
  4. Connect the power steering fluid cooler hose (3) to the steering gear (2).
  5. Clean any excess fluid from the vehicle and remove the drain pans.
  6. Install the radiator grille. Refer to Radiator Grille Replacement (Chevrolet) or Radiator Grille Replacement (GMC) .
  7. Fill and bleed the power steering system. Refer to Power Steering System Bleeding .
scientia non olet · About LEMON Manuals