Stabilizer Shaft Insulator Replacement (2500, 3500)

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Stabilizer Shaft Insulator (2500, 3500)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . Remove the engine shield, if equipped. Refer to Engine Shield Replacement .
1	Stabilizer Shaft Clamp Bolt (Qty: 2) NOTE: Refer to Fastener Notice . Tighten: 50 N.m (37 lb ft)
2	Stabilizer Shaft Clamp
3	Stabilizer Shaft Insulator Tip: Ensure the slit in the insulator is facing front of the vehicle when installed.