LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1015 (Front Suspension System) >> Repair Instructions >> Spring Jounce Bumper Replacement (2500 Series) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: The following service procedure is for 2500 series vehicles.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation .
    3. Fig 1: Removing Nut From Spring Bumper Stud (4WD 15-Series and 2WD 25/35-Series)
    GM348561Courtesy of GENERAL MOTORS CORP.
  3. Remove the nut from the jounce bumper stud.
  4. Remove the jounce bumper.
scientia non olet · About LEMON Manuals