Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing Nut From The Spring Bumper Stud (4WD 15-Series and 2WD 25/35-Series)

Courtesy of GENERAL MOTORS CORP.

Install the jounce bumper.

NOTE: Refer to Fastener Notice .

Install the nut to the jounce bumper stud.
Tighten: Tighten the nut to 30 N.m (22 lb ft).
Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
Lower the vehicle.