Front Wheel Hub, Bearing, and Seal Replacement (1500)

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Front Wheel Hub, Bearing, and Seal (1500)

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle . Remove the brake rotor. Refer to Front Brake Rotor Replacement (JH6, JH7) or Front Brake Rotor Replacement (JD9, JF3, JF7) . Remove the speed sensor. Refer to Front Wheel Speed Sensor Replacement (JD9, JF3, JF7) or Front Wheel Speed Sensor Replacement (JH6, JH7) For vehicles equipped with 4WD, remove the wheel drive shaft from the wheel bearing and hub assembly. Refer to Wheel Drive Shaft Replacement (2500) or Wheel Drive Shaft Replacement (1500) .
1	Wheel Bearing and Hub Bolt (Qty: 3) NOTE: Refer to Fastener Notice . Tighten: 180 N.m (133 lb ft)
2	Wheel Hub and Bearing Assembly

Callout

Component Name

Preliminary Procedure

Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
Remove the brake rotor. Refer to Front Brake Rotor Replacement (JH6, JH7) or Front Brake Rotor Replacement (JD9, JF3, JF7) .
Remove the speed sensor. Refer to Front Wheel Speed Sensor Replacement (JD9, JF3, JF7) or Front Wheel Speed Sensor Replacement (JH6, JH7)
For vehicles equipped with 4WD, remove the wheel drive shaft from the wheel bearing and hub assembly. Refer to Wheel Drive Shaft Replacement (2500) or Wheel Drive Shaft Replacement (1500) .

Wheel Bearing and Hub Bolt (Qty: 3)

NOTE: Refer to Fastener Notice .

Tighten: 180 N.m (133 lb ft)

Wheel Hub and Bearing Assembly