LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1014 (Rear Drive Axle) >> Repair Instructions >> Locking Differential Cam Unit Disassemble (9.5 Inch Axle) >> Disassemble

Locking Differential Cam Unit Disassemble (9.5 Inch Axle): Disassemble

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Measure and record the overall length of the gear assembly from the front of the gear to the thrust sleeve, including the side gear thrust washer.
  2. Remove the guide clips.
    3. Fig 1: Removing Thrust Sleeve Using J 45232 & J 22912-O1
    GM886078Courtesy of GENERAL MOTORS CORP.
  3. Remove the thrust sleeve using the J 22912-O1  (2) and the J 45232  (1), if necessary, and a hydraulic press. See Special Tools .
    4. Fig 2: Locking Differential Side Gear Cam Unit & Clutch Disc Assembly (9.5 Inch Axle)
    GM797776Courtesy of GENERAL MOTORS CORP.
  4. Disassemble the locking differential side gear cam unit and clutch disc assembly as follows:
    1. Remove the clutch discs and the splined discs (7-14).
    2. Remove the wave washer (5).
    3. Remove the fuse disc (4).
    4. Remove the carbon eared disc (3).
    5. Disassemble the cam plate (2) from the cam side gear (1).
scientia non olet · About LEMON Manuals