LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1013 (Disc Brake System) >> Repair Instructions >> Rear Brake Rotor Replacement (JH7) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Wheel Studs, Hub & Rotor Assembly - Rear (W/Dual Wheels)
    GM360809Courtesy of GENERAL MOTORS CORP.
  1. Align the hub and the rotor.
  2. Install each of the new wheel studs into the hub and rotor assembly by performing the following:
    1. Install the stud.
    2. Install 4 washers to the stud.
    3. Install a lug nut to the stud with the flat side of the nut toward the washers.
    4. Tighten the lug nut to draw the stud into the hub and rotor assembly.
    5. Inspect the hub and rotor assembly to ensure the stud is seated completely.
    6. Remove the lug nut and the washers.
  3. Install the hub and rotor assembly to the vehicle. Refer to Rear Axle Hub, Bearing, Cup, and/or Seal Replacement .
  4. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals