LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> ENGINE MECHANICAL - 4.8L, 5.3L, AND 6.0L (4 Of 4) >> Off-Vehicle Repair Instructions (Part 3) >> Oil Level Indicator and Tube Installation

Oil Level Indicator and Tube Installation

  1. Inspect the O-ring seal for cuts or damage. If the oil level indicator tube O-ring seal is not cut or damaged, it may be reused.
  2. Lubricate the O-ring seal with clean engine oil.
  3. Install the O-ring seal onto the oil level indicator tube.
  4. Install the oil level indicator tube into the engine block and rotate into proper position.
    Fig 1: View Of Oil Level Indicator & Tube
    GM260114Courtesy of GENERAL MOTORS CORP.
    5. NOTE: Refer to Fastener Notice .
  5. Install the tube bolt.

    Tighten:  Tighten the oil level indicator tube bolt to 25 N.m (18 lb ft).

  6. Install the oil level indicator into the tube.
scientia non olet · About LEMON Manuals