Clutch Pilot Bearing Removal (RPO HP2)

Tools Required 

J 45849  Bearing Remover. See Special Tools .

1. Install the J 45849  (1) into the flex plate locator (2). See Special Tools .
   Fig 1: View Of J 45849 & Flexplate Locator (RPO HP2)

   Courtesy of GENERAL MOTORS CORP.
2. Using 2 wrenches, rotate the inner shaft of the J 45849  in order to remove the locator. See Special Tools .
3. Remove the flex plate locator (147) from the rear of the crankshaft.
   Fig 2: View Of Flexplate Locator (RPO HP2)

   Courtesy of GENERAL MOTORS CORP.