LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> ENGINE MECHANICAL - 4.8L, 5.3L, AND 6.0L (2 Of 4) >> On-Vehicle Repair Instructions >> Engine Mount Replacement - Left >> Installation Procedure

Installation Procedure

  1. Install the left engine mount to the engine.
    Fig 1: View Of Left Engine Mount & Bolts
    GM679415Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the engine mount bolts to the engine.

    Tighten:  Tighten the engine mount bolts to 50 N.m (37 lb ft).

  3. Lower the engine.
  4. Remove the adjustable jack stands.
  5. For vehicles with 4WD, install the front propeller shaft. Refer to Propeller Shaft Replacement - Front in Propeller Shaft.
  6. Install the engine mount-to-engine mount bracket bolts. (Right side shown, left side similar).
    Fig 2: View Of Engine Mount-To-Engine Mount Bracket
    GM307275Courtesy of GENERAL MOTORS CORP.

    Tighten:  Tighten the engine mount-to-engine mount bracket bolts to 65 N.m (48 lb ft).

  7. Install the wheelhouse panel from the vehicle. Refer to Wheelhouse Panel Replacement in Body front End.
  8. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  9. Lower the vehicle.
scientia non olet · About LEMON Manuals