Removal Procedure

Remove the oil level indicator. Refer to Oil Level Indicator and Tube Replacement .
Remove the intake manifold. Refer to Intake Manifold Replacement .
Remove the coolant air bleed pipe. Refer to Coolant Air Bleed Pipe Assembly Replacement (4.8L, 5.3L, and 6.0L) in Engine Cooling.
Remove the right exhaust manifold. Refer to Exhaust Manifold Replacement - Right (4.8L, 5.3L, and 6.0L Engines) in Engine Exhaust.
Remove the pushrods. Refer to Valve Rocker Arm and Push Rod Replacement .
IMPORTANT: The cylinder head bolts are NOT reusable.
Remove the cylinder head bolts.

Fig 1: View Of Right Cylinder Head
Courtesy of GENERAL MOTORS CORP.

NOTE: After removal, place the cylinder head on 2 wood blocks in order to prevent damage to the sealing surfaces.

Fig 2: View Of Cylinder Head (Right)

Courtesy of GENERAL MOTORS CORP.

Remove the cylinder head.
Remove and discard the cylinder head gasket.

Fig 3: View Of Cylinder Head Gasket (Right)
Courtesy of GENERAL MOTORS CORP.
If required, clean and inspect the cylinder head. Refer to Cylinder Head Cleaning and Inspection .