Park Brake Adjustment (w/Rear Drum)
IMPORTANT:
The following service procedure must be performed to in sure the proper adjustment of the park brake system.
- Ensure that the park brake is fully released.
- Pull the release handle and pull the pedal to full release position, while at the same time pulling the cable strand through the cable conduit.
- With the pedal secure, pull the cable strand until the adjuster fully takes out the cable slack, and the adjuster is fully wound.
- While maintaining tension on the front cable strand, install a pin through the hole in the cover, pedal, and past the adjuster and into the hole mounting bracket.
- Release the tension on the cable strand.