Low and Reverse Band Servo Piston Pin Specification Chart
Refer to the chart in order to determine the correct low and reverse band servo pin length to use. A, B and C on the chart refer to markings on the J 21370-10 Band Apply Pin Gauge. See Special Tools . Numbers 1-7 match the correct piston pin length to the J 21370-10 land indicated by the low and reverse band servo pin inspection procedure. See Special Tools .
Servo Piston Pin Selection
| Pin Length | Pin Identification | |
|---|---|---|
| mm | inch | |
| 83.82-83.97 | 3.300-3.306 | 1 |
| 84.53-84.68 | 3.328-3.334 | 2 |
| 85.24-85.39 | 3.356-3.362 | 3 |
| 85.95-86.10 | 3.384-3.390 | 4 |
| 86.66-87.53 | 3.412-3.446 | 5 |
| 87.38-87.53 | 3.440-3.446 | 6 |
| 88.09-88.24 | 3.468-3.474 | 7 |