Tools Required

J 21366  Converter Holding Strap

1. Rotate the transmission so the converter housing is facing up.
   Fig 1: Aligning Transmission Face Up

   Courtesy of GENERAL MOTORS CORP.
2. Install the torque converter assembly (1). Rotate the torque converter assembly (1) in order to engage the turbine shaft, the stator shaft, and the lugs onto the oil pump drive gear.
3. Install the J 21366  in order to hold the torque converter assembly (1) in place while moving the transmission assembly. Remove the J 21366  prior to installing the transmission into the vehicle.
   Fig 2: Using J 21366 To Secure Torque Converter

   Courtesy of GENERAL MOTORS CORP.