LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Engine Mechanical - 6.6L - On Vehicle Repair Instructions) >> On-Vehicle Repair Instructions >> Engine Oil Pressure Sensor and/or Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the left wheelhouse inner panel. Refer to Wheelhouse Panel Replacement .
    IMPORTANT: Clean the area around the sensor. Do not allow debris to enter the engine.
  2. Disconnect the oil pressure sensor electrical connector.
    Fig 1: View Of Oil Pressure Sensor Electrical Connector
    GM1335546Courtesy of GENERAL MOTORS CORP.
  3. Using J 41712  , remove the oil pressure sensor (1).
    Fig 2: View Of Oil Pressure Sensor
    GM1364822Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals