Input Shaft Assemble

Tools Required

• J 22828  Input and Countershaft Race Installer
• J 38801  Input Shaft Seal Installer. See Special Tools .

1. If removed, install a new input shaft bearing cone using the J 22828  (1) onto the input shaft.
   Fig 1: Installing Input Shaft Bearing Cone

   Courtesy of GENERAL MOTORS CORP.
2. Using the J 38801  (1), install the main drive gear seal into the input shaft retainer. See Special Tools .
   Fig 2: Installing Main Drive Gear Seal

   Courtesy of GENERAL MOTORS CORP.