LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls - 8.1L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Vent Solenoid Valve Replacement (Cab/Chassis) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the EVAP CVS valve line to the CVS, if necessary.
  2. Install the CVS valve and line.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the EVAP CVS valve bracket bolt (1).
    Fig 1: EVAP Line At Clips On Fuel Tank
    GM1228184Courtesy of GENERAL MOTORS CORP.

    Tighten:  Tighten the bolt to 12 N.m (106 lb in).

  4. Install the EVAP CVS line to the clips on the fuel tank.
  5. Connect the EVAP CVS electrical connector (1).
    Fig 2: CVS Electrical Connector (Cab/Chassis)
    GM1238187Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals