Engine Flywheel Removal (Manual Transmission)

Tools Required 

J 44643  Flywheel Hold Tool. See Special Tools .

1. Install the J 44643  to the starter opening in order to hold the flywheel. See Special Tools .
   Fig 1: Locking Flywheel Using J 44643

   Courtesy of GENERAL MOTORS CORP.
IMPORTANT: Do not use the clutch pressure plate bolts. Use a bolt of the correct thread and a length that protrudes enough to use a pry bar.
Fig 2: Accessing Flywheel To Crankshaft Bolts
Courtesy of GENERAL MOTORS CORP.
2. Install two bolts into the clutch pressure plate mounting holes 180 degrees apart.
3. Using a long pry bar, turn the secondary ring of the dual mass flywheel clockwise until the flywheel mounting bolts can be accessed. It may require to turn the secondary ring past the bolt holes in order to compensate the spring tension.
4. Remove the flywheel mounting bolts and discard.
   Fig 3: View Of Flywheel & Mounting Bolts (Manual)

   Courtesy of GENERAL MOTORS CORP.
5. Remove the J 44643  . See Special Tools .
CAUTION: When removing, handling or installing this component wear protective gloves. The sharp edges on the component may be very sharp and may cause injury.
6. Remove the flywheel.