LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 38 (Engine Mechanical - 6.6L - Off Vehicle Repair Instructions (3 Of 3)) >> Off-Vehicle Repair INSTRUCTIONST (Part 3) >> Drive Belt Tensioner and Generator Mounting Bracket Installation

Drive Belt Tensioner and Generator Mounting Bracket Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the drive belt tensioner and generator mounting bracket.
    Fig 1: View Of Generator Mounting Bracket
    GM1334912Courtesy of GENERAL MOTORS CORP.
    2. NOTE: Refer to FASTENER NOTICE .
  2. Install the drive belt tensioner and generator mounting bracket bolts.

    Tighten:  Tighten the drive belt tensioner and generator mounting bracket bolts to 50 N.m (37 lb ft).

  3. Install the drive belt tensioner.
    Fig 2: View Of Drive Belt Tensioner
    GM1334909Courtesy of GENERAL MOTORS CORP.
  4. Install the drive belt tensioner bolt.

    Tighten:  Tighten the drive belt tensioner bolt to 50 N.m (37 lb ft).

  5. Install the electrical harness clip bolts.

    Tighten:  Tighten the electrical harness clip bolts to 10 N.m (89 lb in).

    Fig 3: View Of Electrical Harness Clip Bolts
    GM1334907Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals