LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 37 (Engine Mechanical - 6.6L - Off Vehicle Repair Instructions (2 Of 3)) >> Off-Vehicle Repair Instructions (Part 2) >> Engine Front Cover Cleaning and Inspection

Engine Front Cover Cleaning and Inspection

WARNING: This page is about a different variant/trim than selected.
  1. Remove the O-ring (1) from the engine front cover.
    Fig 1: View Of Engine Front Cover O-Ring
    GM663614Courtesy of GENERAL MOTORS CORP.
  2. Remove the oil pressure relief valve from the engine front cover.
  3. Clean the engine front cover.
  4. Clean the engine front cover mating surfaces.
  5. Inspect the engine front cover mating surfaces for damage.
  6. Inspect the engine front cover O-ring sealing surface for damage.
  7. Inspect the crankshaft front oil seal bore for damage.
  8. Replace the engine front cover if any damage is found.
    9. NOTE: Refer to FASTENER NOTICE .
    Fig 2: View Of Pressure Relief Valve O-Ring
    GM793901Courtesy of GENERAL MOTORS CORP.
  9. Install the oil pressure relief valve with a new O-ring.

    Tighten:  Tighten the oil pressure relief valve to 39 N.m (29 lb ft).

scientia non olet · About LEMON Manuals